Updating hardware information database not responding

Rated 3.98/5 based on 738 customer reviews

These keys must not directly control the brightness after Bit 2 of the _DOS method has been set. Systems without a display must have a physical indicator. Hover Range requirement for full requirement details. Requirements in this area support the debugging capability for the x HCI controller based systems via a debug registers.

This requires the implementation of ACPI brightness methods in the system firmware. Description For any camera device that is built into the chassis of the system and has mechanically fixed direction, the firmware must provide the _PLD method and set the panel field (bits []) to the appropriate value for the panel on which the camera is mounted. Description The following Pen device level requirement must be met and verified upon integration into a system. Every system that has x HCI controller and USB3 external port should support via this port.

updating hardware information database not responding-81

updating hardware information database not responding-49

updating hardware information database not responding-39

If the camera does not support Profiles, then concurrent streaming for Photo Sequence captures a sequence of photos in response to a single photo click. Custom Gestures requirement for full requirement details. General-Purpose Input/Output (GPIO) on an System that Supports Connected Standby GPIO Controllers for pins used by Windows drivers or ASL control methods must appear as devices in the ACPI namespace.

The following methods are required: Bit 2 of the _DOS method must be disabled so that the system firmware cannot change the brightness levels automatically. For example, "Front" indicates the camera faces the user, while "back" indicates that the camera faces away from the end user. Description Systems that support USB 3 are required to have x HCI controller(s) compliant to the x HCI debug specification. There must be at least one user accessible USB 3.0 debug port on the machine.

The following methods are optional: Support for the _BQC method is highly recommended but not required. In addition, bit 18 (Vertical Offset), and bits 14 (Horizontal Offset) must provide the relative location of the camera with respect to the display. HIDCompliant requirement for full requirement details. Description The following Pen device level requirement must be met and verified upon integration into a system. All USB 3.0 ports must protect against a short on the VBus pin such that if another USB host is connected, the USB circuitry is not damaged. There are currently three energy micro-benchmark tests in the HLK including primary storage, network, and primary display.

Bluetooth Radio Management shall only be enabled for internal Bluetooth 4.0 enabled controllers. This will ensure that user will see a minimal disruption in service by ensuring that the Wi-FI device stack recovers and resumes connectivity to the network without the system needing a reboot.

The on/off state of Bluetooth-enabled controllers shall be controllable via software as described in Bluetooth Software Radio Switch. Description The following Pen device level requirement must be met and verified upon integration into a system. Devices must report support for Hang Detection and Recovery in WDI_GET_ADAPTER_CAPABILITIES.

Leave a Reply